Using high current 2A charging IC, the charging time is shorter Ģ5. Expand a USB power output interface, 5V/1A output (can be used as a power bank) Ģ4. Upgrade firmware through virtual U disk, no programmer is needed, only one USB cable is needed to upgrade firmware Ģ2. Full touch screen design, support 3 side buttons at the same time, flexible and convenient operation Ģ3.

Using 5000mAh super-capacity lithium battery, the battery life can reach 7 hours Ģ0. The radio frequency interface is SMA, which is convenient for connecting all kinds of DUTs ġ9. Compact design, body size 125mm*75mm*20mm, compact and portable ġ8. The aluminum alloy case is used to effectively shield electromagnetic interference, making S21 a dynamic range better than 80dB within 1GHzġ7. ġ5.4.3 inch IPS LCD screen, IPS TFT (800x480) viewing angle is close to 180°, long-term use will not hurt your eyes ġ6. It can measure S parameters, voltage standing wave ratio SWR Smith chart, phase diagram, group delay. Scan time: about 1.9s/1 time (50kHz ~ 3000MHz full frequency band)ġ4. Setting save: 5 (after saving, it can be directly recalled when it is used next time it is turned on, no need to recalibrate, the next time it is turned on, the saved parameters before the last shutdown are automatically recalled)ġ3. Mark: 4 mark points (mark mark bar can be moved up and down on the screen)ġ2. Number of calibration points: 101 pointsġ1. USB interface: USB Type-C communication mode: CDC (serial)Ĩ. RF output power: -9dbm (error within 1GHz: plus or minus 1db) Ĥ. Measuring frequency range: 50KHz-3000MHz Ģ.

The measurement is more accurate and more practical with a simple, flexible and fast operation interface.ġ. The measurement range is extended to 50KHz-3000MHz, and the dynamic range is larger, reaching 80db, which can be used to debug the UV frequency. The NanoVNA-V2 portable vector network analyzer is a new generation. The very capable and inexpensive NanoVNA vector network analyzer hasīecome very popular among hams.

Nanovna 3ghz